Primer H

Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.

Free of salts known to be damaging to building materials.

Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C

Shake well before use.

Apply evenly to the material using a brush, roller or spray.

If needed, repeat the application.

Do not let excess material build up on the surface.

Glossy layers must be avoided.

Structural defects such as cracks, cracked joints, defective connections and rising damp must be remedied first.

Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

Can be overcoated after 24 hours at +20 °C and 65% relative humidity.

As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

Brush, roller, surface brush, suitable spraying equipment

After use and before prolonged interruptions of work clean tools with Thinner V 101.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 200 - 400 ml/m² depending on the substrate

Apply to a large enough trial area to determine the precise amount required.

The relevant test certificates must be observed when planning and carrying out work.

The current technical regulations must be observed.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

Always set up a trial area/trial areas first.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.