Power Protect R 15

The substrate must be clean and capable of bearing a load.

The substrate must be level.

Level off and even out highly uneven substrates – use SP Level to close up joints and even out surfaces.

Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

Use the material to level out any unevenness of < 8 mm in the substrate.

Apply the material vertically to the substrate with a toothed smoothing trowel.

Press on the board, beginning at the bottom.

A full-surface bonding is to be achieved.

Mark the desired dimensions on the board.

Cut with a cutter knife or keyhole saw.

Rework the cut edges with a rasp or file if necessary.

Place the boards, starting at the bottom.

Avoid cross joints.

Make sure that the board surface is aligned correctly (the label "front side" must be visible after application).

Then, use PP Fill to smooth off and create fine, closed surfaces that are ready for painting.

Unlimited if stored in frost-free conditions.

Approx. 4.5 boards/m²

Typical inherent odour after installation, while the finishing plaster is drying.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

The product must be disposed of in accordance with the official regulations.