ZM HF

The substrate must be clean, solid and free of oils, grease and release agents.

The substrates may be slightly damp but must not have a film of liquid.

Mortar improvement

Dilute the material with water and mix well (observe the correct mixing ratio).

Use mixture as mixing water for the mortar.

Adhesive primer

Dilute the material with water and mix well (observe the correct mixing ratio).

Apply the mixture evenly over the prepared substrate.

In the case of highly absorbent substrates, repeat the process within 24 hours if necessary.

Always dilute the material with water.

Do not let excess material build up on the surface.

Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

Wide brush, broom, spatula or trowel

Clean tools, equipment and splashed material immediately while fresh with V 101.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

For bonding layers, grouts: approx. 0.1 - 0.2 kg/m²
For bonding mortar: approx. 1.0 kg on 1 - 2 m², depending on the layer thickness

Apply to a large enough trial area to determine the precise amount required.

Always set up a trial area/trial areas first.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.