• Acryl SK

    Article No. 780112

    Acryl pro

    Plastoelastic sealing and adhesive compound


    Product variants
    Variant table
    Colour: transparent | 7801
    Size / Quantity
    12 x 310 ml

    Note: This container size is being phased out and is only available to a limited extent.

    Downloads & documents

    Technical Data Sheet
    Safety Data Sheet
    ➥Show all documents (in different languages) for download / dispatch

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    Skin formation Approx. 15 min. (+23°C/50% RH)
    Viscosity Paste-like/stable
    Density
    (DIN EN ISO 1183-1A)     1.07 g/cm³

    Once fully cured

    E-modulus
    100% (DIN EN ISO 8339)     0.02 N/mm²
    Elongation at break
    (DIN EN ISO 8339)     > 200%
    Volume loss
    (DIN EN ISO 10563)     Approx. < 30%
    Permissible total deformation
    (DIN EN 15651-1)     ± 7.5%

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Product details Application Usage / application examples Notes

    Field of application

    • For use outdoors
    • Roofing trade
    • Tinsmiths and installers
    • General bonding work in construction and woodworking

    Properties

    • Solvent-based
    • High adhesive power even on damp substrates
    • Compatible with bitumen
    • Universal adhesion
    • Can be overcoated
    • Contains solvents
    • Preparation
      • Preparations

        The substrate must be clean, free of grease and capable of supporting a load. Metal must be bare.

    • Application
      • Application temperature: min. -5 °C max. 35 °C
      • Gun for sealing compounds
      • Application requirements

        Temperature of the material, air and substrate: from min. -5 °C to max. +35 °C

      • Apply the material on one side, spread evenly and press the parts together.

        Use a moistened spatula to remove excess material.

    • Application instructions

      • When used on coatings, the material may cause (temporary) initial dissolving; set up a trial area.

        Do not allow the product to come into contact with polystyrene.

        Not for permanent water loads.

        Do not heat the reacted material to above +60 °C.

        Bubbles may form in the material when applied at high temperatures and in large gaps.

    • Working tools / cleaning
      • Gun for sealing compounds

      • Manual gun, sealant gun, spatula, joint smoothing trowel

      • Clean with V 101 in the fresh and reacted state.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers

      • At least 36 months in unopened, original containers stored cool, dry and protected from frost.

    • Usage
      • Total application rate approx. 100 ml / cm² x m

      • Approx. 100 ml/m for a 1 cm² joint cross-section

    • General information

      • Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions

      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations

      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.