Article No. 283405
Chloride-free, fast-setting cement for universal use
Product specifications
24 h = approx. 25 N/mm²
28 days = approx. 50 N/mm²
6.0-7.5 l/25 kg
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Fast-setting mortar for quick mounting of add-on parts
- Rapid repair of leaking areas, seepage areas and water inrushes
- Casting with open and closed moulds
- Accelerator for mortars with normal setting properties
Properties
- Very high early and final strength
- Reacts within minutes (5 minutes)
- Water impermeable
- Freeze/thaw-resistant
- Can be mixed with cements as per DIN EN 197-1
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Pre-wet the substrate so that it is slightly moist.
-
-
Application
-
Application requirements
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
-
Quick mounting
Fill the assembly area with material, applying light pressure.
Accelerator
Add 10-20% by weight of the material, depending on the desired setting time, to the cement mortar.
-
-
Application instructions
-
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.
Leftover product in the mixing containers accelerates setting.
-
-
Working tools / cleaning
-
Mixer, trowel, filling knife
-
Clean tools with water while the material is still fresh.
-
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
-
Usage
-
Approx. 2.0 kg/l void
-
-
General information
-
Do not use on gypsum-based substrates.
The mixing water must be of drinking water quality.
May contain traces of pyrite (iron sulphide).
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Alkaline binders may cause a dissolution process on non-ferrous metals.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-